Made the mould for the roof scoop

And made the mould for the outer skin of the boot lid.

Other than that, it was a lot of sanding and priming, getting other bumpers and panels ready for paint.

Added the steering lock stops and the sway bar mounts to the front lower control arms.  Then made a mirror image of it for the other side.

Made a press in sleeve to adapt the ABS mounting hole to suit the Monit rally computer wheel probe.

Also took the stock ABS ring and welded some larger rings on it, so that the Monit has something to pick up a signal from.

Started working on the mounts for the wheel brace and jack.

Ans the very raw beginnings of an adaptor to mount my TPS sensor to the quad throttle bodies.

Took the stock engine mounts out and made up the real set.  Much lighter and stronger than the stock ones.

Made a short shifter and extended gear lever.

And finally started making a mold of the boot lid.  This is the inside of the boot, which while not needed for the rules, I needed in order for the boot seal to be effective and keep the dust out.